Guide 11 / 17
Guide 11 of 17 5 min read

Post-Bake Drill Guide Caps & Curved Doming Arch Jigs

Drill dead-center assembly holes after baking without wandering Dremel bits, and cure sculptural arched earrings cleanly using custom contour-matched baking forms.

# Precision Snap-On Post-Bake Drill Guide Cap

Many clay artists prefer baking earrings completely solid and drilling jump-ring holes afterward so raw clay edges never deform around a piercing tube. Open Post-Bake Drill & Doming Jigs and check Post-Bake Drill Guide Cap to auto-generate a recessed cradle matched to your exact cutter shape.

Each jig features a 45-degree countersunk Dremel funnel guiding your pin vise or rotary drill bit straight downward (1.0 – 3.5 mm Drill Bit Bore, default 1.8 mm), plus a generous thumb-eject slot along the side wall so baked pieces slip out effortlessly.

Custom-fit jigs are automatically sized to your exact earring contour and packed on the build plate right beside your cutter.

# Calibrating Baked Clay Fit Clearance (0.15 – 0.80 mm)

Different clay formulas shrink slightly during baking, and sanding beveled edges shaves a fraction of a millimeter off the perimeter. Adjust Baked Clay Fit Clearance (default 0.35 mm) so cured earrings seat snugly with zero rattle while accommodating cured edges cleanly.

Parameter / Control Range / Options Default Maker Notes
Drill Bit Bore 1.0 – 3.5 mm 1.8 mm Add 0.1–0.2mm above your actual twist drill bit diameter so plastic friction does not melt.
Baked Clay Fit Clearance 0.15 – 0.80 mm 0.35 mm Per-side pocket clearance around your cut outline for easy drop-in seating.
Arch Dome Rise 2.0 – 14.0 mm 6.0 mm Vertical parabolic curvature height beneath cured clay shapes during oven baking.

# Curved Doming / Baking Arch Forms

Want statement hoops, petals, or boho slabs to catch overhead light cleanly along curved sculptural contours? Enable Doming / Baking Arch Form and adjust Arch Dome Rise (2.0 – 14.0 mm, default 6.0 mm) to generate a solid convex cradle sized cleanly under your earring footprint.

# Critical Filament Warning for 130°C Polymer Clay Ovens

Standard PLA softens at ~55–60°C and will warp flat in a curing oven. Print all Doming / Baking Arch Forms in high-temp filaments like PETG, ASA, ABS, or Polycarbonate (PC), and always verify your actual oven rack temperature with an independent thermometer (≤ 130°C / 265°F for PETG, lightly dusted or lined with parchment paper).