One-Piece Imprint Cutters: Deboss & Emboss Relief
Cut the outer earring outline and press intricate interior artwork into raw clay in one downward motion using calibrated recessed ribs.
# How One-Piece Imprint Cutters Work
In Imprint mode, your cutter combines two coordinated heights bonded to a solid contour-matched backing plate:
- The outer perimeter wall stands at full Blade Depth (
12.0 mm) with a sharp0.4 mmtip to slice cleanly all the way through your clay slab to the tile. - The interior relief artwork stops slightly shorter—set back by your Imprint Depth—so the top pattern presses cleanly into the surface without punching through the earring back.
# Calibrating Imprint Depth Against Clay Thickness
Think of Imprint Depth (0.5 – (Blade Depth - 1) mm, default 1.5 mm) as the distance your outer blade penetrates deeper than the inner ribs when the blade tip bottoms out on your work tile.
With a standard 2.5 mm clay slab (setting #1–#2 on most pasta machines), setting Imprint Depth to 1.5 mm leaves 1.5 mm of solid clay behind the grooves and presses 1.0 mm deep relief lines into the top face. Studio displays an automatic warning if Imprint Depth meets or exceeds your clay slab thickness so you do not accidentally slice thin petals loose.
| Parameter / Control | Range / Options | Default | Maker Notes |
|---|---|---|---|
| Imprint Depth | 0.5 – (Depth - 1) mm |
1.5 mm | 1.2–1.6mm works cleanly on 2.5–3.0mm slabs; reduce on 1.8mm thin slabs. |
| Inner Wall (mm) | 0.4 – 2.0 mm |
0.4 mm | 0.4–0.6mm stamps crisp botanical veins cleanly; 0.8mm paints broader bold channels. |
# Deboss (Pressed) vs. Emboss (Raised)
Every pattern supports instant polarity inversion inside the Imprint accordion:
- Deboss (Pressed): Raises the line artwork slightly proud inside the cavity, pressing recessed grooves into your clay ready for antique acrylic wash or mica infill.
- Emboss (Raised): Creates an inverted pocket background that pushes surrounding clay down, leaving petals, stems, or lettering sculpted outward in bas-relief.
# Solid Silhouette Backing Plate & Demolding
Instead of floating open bridges, CutClay seals one-piece imprint cutters with a stiff contour-matched top plate. Lightly mist stamps with water or brush with cornstarch before pressing straight down and lifting vertically—never wiggle side to side, or embossed edges will smear.